Independent test reports from the IKT, the US Navy, the Concrete Products Association and from several other independent testing houses are available on request.
The Ultracoat system has been tested to the following standards
ASTM C297 - Tensile Strength
ASTM D2240 - Durometer Hardness
D2584 – Volatile Matter Content.
D4414 - Wet Film Thickness by Notch Gages
D4541 – Pull-off Strength of Coatings Using a Portable adhesion Tester.
D4541 - Concrete Failure Chemical Resistance to: Sulfuric Acid, 70%
D543 – Resistance of Plastics to Chemical Reagents.
D543 – Water Vapor Transmission of Organic Coating Films.
D543 - Immersion Service
D638 – Flexural Properties of Unreinforced and Reinforced Plastics
ASTM D638 – Tensile Properties of Plastics.
ASTM D638 - Flexural Strength
ASTM D638 - Tensile Elongation
ASTM D638 - Tensile Strength
ASTM D695 – Compressive Properties of Rigid Plastics.
ASTM D695 - Compressive Strength
ASTM D695 - Flatwise Tensile Strength Of Sandwich Constructions
ASTM D790 – Flexural Properties of Unreinforced and Reinforced Plastics.
ASTM D790 - Bond Strength – Concrete
ASTM D790 - Flexural Modulus
ASTM D790 - Flexural Strength
ASTM E84 - Test Method for Surface Burning Characteristics of Building Materials
